Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec DH 25 S
Summary of Contents for Trotec DH 25 S
- Page 1 DH 25 S / DH 65 S ORIGINAL INSTRUCTIONS CONDENSER DRYER...
-
Page 2: Table Of Contents
• Let the device dry out after a wet clean. Do not operate it Information marked with this symbol helps you to carry when wet. out your tasks quickly and safely. • Do not use the device with wet or damp hands. condenser dryer DH 25 S / DH 65 S... - Page 3 • The entire refrigerant circuit is a maintenance-free, hermetically sealed system and may only be maintained or repaired by specialist companies for cooling and air- conditioning or by Trotec. condenser dryer DH 25 S / DH 65 S...
- Page 4 Trotec. Safety signs and labels on the device Note Do not remove any safety signs, stickers or labels from the device. Keep all safety signs, stickers and labels in legible condition. condenser dryer DH 25 S / DH 65 S...
- Page 5 Dangers can occur at the device when it is used by untrained people in an unprofessional or improper way! Observe the personnel qualifications! Warning The device is not a toy and does not belong in the hands of children. condenser dryer DH 25 S / DH 65 S...
-
Page 6: Information About The Device
• Do not use the power cable to drag the device. • Only wheel the device on firm and level surfaces. After transporting the device, proceed as follows: • Set up the device in an upright position after transport. condenser dryer DH 25 S / DH 65 S... -
Page 7: Assembly And Start-Up
• Make sure that no curtains or other objects interfere with the air flow. • When positioning the device, particularly in wet areas, secure it locally with an RCD (residual current device) which complies with the respective regulations. condenser dryer DH 25 S / DH 65 S... - Page 8 Connecting the power cable • Insert the mains plug into a properly secured mains socket. 3/4" 2. Make sure that the condensation drain hose is properly connected to the device and free of damage. condenser dryer DH 25 S / DH 65 S...
-
Page 9: Operation
For increasing the desired relative button humidity level (30 % to 80 %) 16 Decrease value For reducing the desired relative button humidity level (30 % to 80 %) 17 POWER button Switching the device on and off condenser dryer DH 25 S / DH 65 S... -
Page 10: Errors And Faults
To ensure that the correct error table is used, please verify the software version in the segment display (10) first when starting the device. The following error messages can be displayed on the segment display (10): condenser dryer DH 25 S / DH 65 S... - Page 11 The defrost thermostat is malfunctioning. The device will switch to standby mode. Have the device checked by a specialist company for cooling and air- conditioning, and have the defrost thermostat exchanged if necessary. condenser dryer DH 25 S / DH 65 S...
-
Page 12: Maintenance
12. Date: ........Signature: ........ Signature: ......... Signature: ......... Signature: ......... 13. Date: ......... 14. Date: ........15. Date: ........16. Date: ........Signature: ........ Signature: ......... Signature: ......... Signature: ......... condenser dryer DH 25 S / DH 65 S... - Page 13 • The entire refrigerant circuit is a maintenance-free, 5. Put the air filter back in. hermetically sealed system and may only be maintained or repaired by specialist companies for cooling and air- conditioning or by Trotec. condenser dryer DH 25 S / DH 65 S...
- Page 14 1. Remove the air filter (6) at the air inlet from the device. 3. Allow the filter to dry completely. Do not insert a wet filter into the device! 4. Reinsert the air filter into the device. condenser dryer DH 25 S / DH 65 S...
-
Page 15: Technical Annex
B: rear: 50 cm 50 cm C: side: 50 cm 50 cm D: front: 50 cm 50 cm Length x width x height 420 x 350 x 580 mm 580 x 730 x 580 mm Weight 34 kg 55 kg condenser dryer DH 25 S / DH 65 S... - Page 16 Wiring diagram DH 25 S condenser dryer DH 25 S / DH 65 S...
- Page 17 Wiring diagram DH 65 S condenser dryer DH 25 S / DH 65 S...
- Page 18 Evaporator closing Sx Front grille Handle Wheel Ø50 Cover Wheel Ø50 with brake Display protection Evaporator closing Dx Display Filter lane Display support Filter + filter holder Display label Rear grille condenser dryer DH 25 S / DH 65 S...
- Page 19 Sanhua coil Evaporator top Solenoid valve Thermostat K50 Solenoid valve with sanhua coil Plastic fan Condenser Motor fan Upper condensate tray Electrical cabinet panel Evaporator Electronic board PCB Lower condensate tray condenser dryer DH 25 S / DH 65 S...
- Page 20 The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. Spare part Spare part cardboard box PSE corner PSE top PSE bottom condenser dryer DH 25 S / DH 65 S...
- Page 21 Display label Filter lane Display support Rear grille Display Filter + filter holder Display protection Evaporator closing Sx Wheel Ø50 Handle Wheel Ø50 with brake Cover Evaporator closing Dx Front grille condenser dryer DH 25 S / DH 65 S...
- Page 22 Evaporator top Bottom Lower condensate tray Sanhua coil Thermostat K50 Solenoid valve Cooling Solenoid valve with sanhua coil Ellectrical cabinet panel Condenser Electronic board PCB Upper condensate tray Fan running capacitor Evaporator condenser dryer DH 25 S / DH 65 S...
- Page 23 The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. Spare part Spare part cardboard box PSE bottom PSE top PSE bottom plate PSE corner condenser dryer DH 25 S / DH 65 S...
-
Page 24: Disposal
We – Trotec GmbH – declare in sole responsibility that the product designated below was developed, constructed and produced in compliance with the requirements of the EC Machinery Directive in the version 2006/42/EC. Detlef von der Lieck, Managing Director condenser dryer DH 25 S / DH 65 S... - Page 25 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...