Schduled Record; Event List - Samsung NETWORK DIGITAL VIDEO RECORDER User Manual

detection is triggered.
Note: PAL: (1~4P/6P/8P/12P/25P) NTSC=15P, PAL=12P on default.
ALARM RECORD DWELL 5SEC (1-30)
Use ◄ or ► button to set the dwell time for alarm recording when external alarm or motion
detection is triggered.
When external alarm is triggered and within the dwell period:
the screen will be switched into 4 format.
-
The corresponding camera will be marked ID "EXT"
-
RECORD QUALITY HIGH(BEST/HIGH/MEDIUM/LOW)
Use ◄ or ► button to select the BEST, HIGH, MEDIUM or LOW setting so there is a total
of four levels of recording quality that can be chosen from. The higher the quality, the
higher the amount of storage will be consumed. Thus, this setting should be carefully
chosen as it will affect the usage of hard disk storage.
A table of relationship between quality, record speed and hard disks is attached for
Reference.
MOTION EVENT MIGRATION OFF
You can decide to include or exclude motion events by turning on or turning off in this
option. The default setting is off.
EXIT
Exit from the RECORD SETUP menu
5. SCHEDULE RECORD
ˇ
O O O O O O O O O O O O O O O O O O O O O O O O
： ： ：
0 3 6
PRESS (UP,DOWN) TO SELECT
PRESS (ENTER) TO SET, (MENU) TO EXIT
Contents:
1
SCHEDULE RECORD
There are 24 circles in the schedule table, which represent 24 hours.
Every circles has 3 options to select:
O : represents "fully record"
X : represents "no record"
A : represents "alarm record"
Use the ◄ or ►button to select items.
Press ▲ or ▼ button to select the O/ X / A (Fully / No / Alarm Record).

6. EVENT LIST

Press ◄ or ► key on "EVENT LIST" than windows will appear as below:
> 01 2004/JUN/25 12:13:16 REC
02 2004/JUN/25 11:14:21 PWR
03 2004/JUN/25 10:03:04 REC
04 2004/JUN/25 09:35:24 ALM CH1
Use "▲ or ▼" key to select event which needs to be played，location of " > " symbol will move up
SCHEDULE RECORD
： ： ：
9 12 15
EVENT LIST
MASTER HARD DRIVE
Press the MENU button to go into the
main menu.
Use the ◄ or ► button to select items.
： ： ：
18 21 24
Press the ▲ or ▼ button to confirm the
selection.
Press MENU to escape to exit the set
up mode.
6