Gaggenau AH 590-720 Operating And Assembly Instruction Manual page 7

Freely suspended insular hood

Hide thumbs Also See for AH 590-720:

") 200

Fig. 19

Fig. 20

All manuals and user guides at all-guides.com

(13

") 346

Note:

the extractor hood is to be installed to a kitchen

ceiling or suspended ceiling. Ensure that the

ceiling is capable of providing a firm hold for a

maximum weight of hood and accessories of 60 kg.

Before marking the securing holes, make sure that

no electricity wires or water pipes or other wires/

pipes are laid at the drilling points in the ceiling.

Before installation check the enclosed wall plugs

and screws are suitable for your ceiling. If neces-

sary use special wall plugs.

Installation:

1. Using the drilling template mark the position of

the screws on the ceiling.

2. Drill 4 holes Ø 8 mm for the wall plugs. Push the

plugs flush with the ceiling (Fig. 19).

3. Turn two screws to a 10 mm gap. Both screws

are placed in a position, in which at a later stage

of the installation the key-holes of the suppor-

ting frame are found (namely front left and back

right from the control panel of the hood).

4. Place the hood on a suitable base. Connect the

air outlet pipe to the hood.

5. Screw the support frame to the hood with

4 screws. The marking "FRONT" must be on the

same side as the control panel (Fig. 20).

Ventilation ducts LK 590-020/030/021/031

only: the enclosed extension module should be

mounted on top of the support frame. Follow the

above instructions for mounting the support

frame and hood.