Ariens Sno-Thro 920 Series Owner's/Operator's Manual page 12

Install Discharge Chute Crank
(Figure 7)
1. Slide Chute Crank through the opening
in the control panel.
NOTE: Be careful not to damage nylon
bushing when attaching crank to the dash.
2. Connect the chute crank to the pinion
gear on discharge chute with hairpin.
1. Chute Crank
2. Control Panel
3. Pinion Gear
4. Hairpin
Figure 7
Install Remote Deflector Cable
(920308)
(Figure 8 and 9)
1. Slide cable through clip on top of
discharge chute pedestal (Figure 8).
2. Bend clip closed around cable.
3. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
.
2
1. Remote Deflector Cable
2. Remote Deflector Control
1
3. Cable Clip
4. Wire Cable Hook
5. Cable Mounting Bracket
4. Pull rubber seal cap away from snap
5. Install snap fitting into cable bracket's
3
NOTE: The cable mounting bracket located
underneath the control panel contains two
mounting holes. Use only the upper mounting
hole; the one closest to the dash.
4
6. Position rubber seal cap over the top of
7. Move deflector control lever to forward
8. Attach cable eye to pin on bottom of
NOTE: Hold down chute deflector cap, if
needed, for more cable slack.
9. Secure cable eye to control lever with
10. Test controls to be sure deflector works
OS8060
NOTE: If deflector does not follow full range
of travel See Remote Discharge Deflector
Control Adjustment (920308) on page 24.
GB - 12
4
3
1
Figure 8
fitting.
upper mounting hole.
snap fitting.
most position.
deflector control lever.
washer and hairpin.
properly.
2
5
OS8064