Safety Warnings; Assembly/Installation Instructions - BorMann Elite BFN6110 Quick Start Manual

EN

Safety warnings

1. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
2. Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules, before reverse the fan.
3. Warning: If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact the manufacturer, its service agent or suitably
qualified persons.
4. The replacement of parts of the safety suspension system device shall be performed by the manufacture, its service agent or suitably qualified persons.
5. The fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a sufficient strength to withstand 4 times the weight of the
ceiling fan;
6. The mounting of the suspension system and all electrical connections must be performed only by suitably qualified persons.
7. Do not install paddle fan less than 9 feet between floor and lowest edge of fan blades.
8. All wiring must be in accordance with the National Electrical Code and local electrical codes. Electrical installation should be performed by a qualified licensed
electrician.
9. Do not operate reversing switch while fan blades are in motion. Fan must be turned off and blades stopped before reversing blade .
10. Do not use water or detergents when cleaning the fan of fan blades. A dry dust cloth or lightly dampened cloth will be suitable for most cleaning.
11. After making electrical connections, spliced conductors should be turned upward and pushed carefully up into outlet box. The wires should be spread apart
with the grounded conductor and the equipment-grounding conductor on one side of the outlet box.

Assembly/installation instructions

Unscrew the retaining screws located around the perimeter of the top cover and remove the mounting base/plate from the cover (this step may not be necessary).
1. Mounting/attachment plate: mounting equipment for ceiling suspension such as hooks, dowels or other attachments must be of the necessary specification
to support 4 times the weight of the ceiling fan. Screw the suspension/attachment base using suitable means of attachment to the ceiling or to a suitable
mounting bracket. Ensure that you position the base with the correct side (flat) touching the surface of the ceiling/mounting base.
2. Insert the hanger through the cover (cup) and make sure that the protrusion of the inner "tooth" hole of the cover is within the recess of the plastic part of
the hanger. Carefully thread the motor wires through the suspension tube and make sure all ends are on the top side. Secure the motor to the hanger using
the Locking shaft and Shaft Retaining Clip and the locking screw using the following illustration.
3. Connect the control device according to the following picture.
The wires (two) located on the right side of the control device should be connected to the mains power supply (electrical wires).
For safety reasons, the suspension base has a grounding wire, make sure to connect the corresponding grounding wire of the control device to the grounding
and earthing of the mains.
After the connection procedure is complete, carefully place the control device in the cup.
4. Hang the motor on the suspension so that you can continue making the remaining electrical connections as shown in the following illustrations.
The wires (three) located on the left side of the control device should be connected to the (electrical wires) of the suspension.
To make the connection process easier, you can hang (tie) the motor on the hook of the base.
CAUTION: The fan installation and electrical connections should only be carried out by a qualified electrician.
4
Upper cover
(''cup'')
WWW.BORMANNTOOLS.COM
Suspension plate
Grounding
cable
Retaining screws