Advertisement
Available languages
Available languages
EN
WARNING: It is important that you read these instructions before
using your product and we strongly recommend that you keep
them in a safe place for future reference.
Safety Instructions
1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, it should be repaired by the repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replaced by a same cord from the manufacturer or its service agents.
5. When the appliance is not in use, switch it off and unplug it.
6. Do not insert things to air outlets and inlets, in order to avoid damage.
7. Do not use the appliance near explosive and combustible gas.
8. Use the appliance only on a flat surface.
9. Do not use outdoors.
10. Do no turnover the appliance. Unplug the power supply If it is toppled over and there have some water in the body. Dry the body before use.
11. Clean the appearance with a lightly damp cloth. It can clean with neutral detergents. Do not rinse with water.
12. Do not make air outlets and inlets near the wall or curtain.
13. Do not knock or shake the body when use, otherwise it may cause stop.
14. The appliance must not located immediately below a socket outlet.
The rating current of socket should exceed 10A.
15. Do not use the appliance in the immediate surrounding of a bath,a show or a swimming pool.
16. This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities or lack of experience and knowl-
edge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
17. Children should be supervised to ensure that they do not play with the appliance.
Assembly Instructions
• Remove the packaging material from the fan control box.
• Remove the screws from the two extremities of the base tube.
• Insert the tube into the fan body.
• Align the screws hole and tighten the holding screws onto the base.
NOTE: When installing the control box, make sure the electrical wires are located on the outside of the base.
Operating instructions
• Set your fan on a level dry surface.
• Plug the power cord into 230V volt AC wall outlet.
• The 3 speeds system is designed to give you maximum flexibility and to meet all your air circulation needs.
• LOW or MED speed setting can be used for most of your requirements.
• High speed should only be necessary in exceptional circumstances.
• Select the desired speed by using the rotary control switch.
• Adjust to your desired air stream by tilting the fan assembly to the require position.
Care and storage
• Turn the control to OFF and unplug the fan before cleaning.
• Use only a soft, damp cloth to clean the fan.
• Do not place the fan in water and never allow water to drip into the Motor Housing.
• Do not use gasoline, paint thinner or other chemicals to clean the fan.
• To clean the fan Blade,Remove the Front grill and Wipe the Blade and Grills.
• Reassemble the fan by snapping the Front Grill into place.
• Store the fan in its original box or cover the fan to protect it from dust.
• Store it in a cool, dry place.
Disposal of electrical and electronic equipment
To protect our environment and to recycle the raw materials used as completely as possible, the consumer is asked to return unserviceable
equipment to the public collection system for electrical and electronic. The symbol of the crossed indicates that this product must be returned
to the collection point for electronic waste to feed it by recycling the best possible raw material recycling.
By ensuring this product you will prevent possible negative effects on the environment and human health, which could otherwise be caused
due to improper disposal of that product. The recycling of materials from this product, you will help to preserve a healthy environment and
natural resources.
1
WWW.BORMANNTOOLS.COM
Advertisement
