Installation
February 2022
The protective cover is available in ABS plastic or stainless steel.
Table 2-3: Protective cover
Material
ABS plastic
Stainless steel
Procedure
1. Place the protective cover on top of the detector.
2. Secure the protective cover by tightening the screw.
2.7
Aim the detector
Aim the detector toward the center of the detection zone and make sure you have a
completely unobstructed view of the protected area.
Emerson recommends positioning the detector tilted down at a 45° angle to maximize
coverage and prevent accumulation of dust and dirt.
Do not begin installation until all conceivable considerations regarding detection location
have been taken into account.
20
Note
When installing the stainless steel protective cover, the same installation
instructions apply.
Part number
00975-9000-0020
00975-9000-0021
Emerson.com/Rosemount
Reference Manual
00809-1400-4975