Table of Contents
Advertisement
Loudspeaker System Specifications
Dimensions (H x W x D):
Front:
24.50 in. x 16.10 in. x 15.00 in.
622 mm x 409 mm x 381 mm
Rear:
22.75 in. x 8.75 in. x 15.00 in.
578 mm x 222 mm x 381 mm
Net Weight:
42 Lbs.
(19.1 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS
Internal power amplifiers Power Ratings (@120 VAC line):
Total of 980 watts peak dynamic power
Woofer - 840 watts peak dynamic power
Sine wave Power*: 375 watts @ less than 1% distortion
Tweeter - 140 watts peak dynamic power
Sine wave Power*: 50 watts @ less than 1% distortion.
*
Before DSP compression and limiting engages.
Electronic Input Impedance (Nominal):
Line: 20 k ohms balanced (1/4" and XLR), 15 k ohms unbalanced 1/4",
6.4 k ohms 1/8" jack
Mic: 2.7 k ohms balanced (XLR) No phantom power available.
Input Sensitivity for Full Output (Channel Input Level knob full CW, Master
DSP gain full-up, DSP CH1 or CH2 at 0 dB):
1 / 4" TRS /XLR combo jack: 0.50 V RMS
See Level Control Adjustment section for more details under different channel
and Main Gain settings.
DSP Specifications: DSP Input and Output is at 48 kHz and 24 bits, internal
processing is 56 bit double-precision. Latency: 1.2 ms
Infrasonic filter protection: Minimum 36 dB/octave roll-off, 48 dB/octave roll-off
with adjustable input filters engaged.
Nominal Amplifier Frequency Response: +0, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
Overdrive Dynamic Range: Greater than 15 dB
42
Advertisement
Table of Contents
