Table of Contents
Advertisement
Music Presets
Creating a User Preset
User Preset Numbers
Preset areas numbered F:001 through F:050 are for storage
of user presets. You can have up to 50 user presets stored in
memory at one time. You can recall a stored user preset after
pressing the L-9 ([F] USER RHYTHMS) button. See "To
perform using a music preset" (page E-54) for more
information.
To create and save a user preset
1.
Perform steps 1 through 4 under "To perform
using a music preset" (page E-54) and select
the music preset you want to edit in order to
create your user music preset.
2.
Configure tone and other settings referring to
"Music Preset Settings" (page E-56).
3.
While holding down the R-13 (FUNCTION)
button, press the C-17 (MENU) button.
• This displays the MP (music preset) editor screen like
the one shown below.
• Pressing the R-16 (ENTER) button here will change to
a screen for editing the chord progression. See "Editing
a Chord Progression" (page E-62) for more information.
4.
Use the R-17 (t, y) buttons to move the 0 to
"Parameter" and then press the R-16 (ENTER)
button.
• This displays the parameter menu.
E-58
5.
You can change each of the parameters on the
parameter menu as required.
(1) Use the R-17 (t, y, u, i) buttons to move the 0
to the parameter you want to change.
(2) Use the dial or the R-14 (–, +) buttons to change the
setting value.
• Pressing the R-14 (–, +) buttons at the same time
returns a parameter to its initial default setting.
• The following explains the meanings and setting
ranges of the on-screen items. The settings marked
with an asterisk (*) in the "Setting Range" column
are initial defaults.
Item name
Description
Synchro
Specifies the Auto
(Synchro type)
Accompaniment synchro
start standby type.
IntroChd
Specifies the chords of the
(Intro chord)
Auto Accompaniment intro
pattern.
EndingChd
Specifies the chords of the
(Ending chord)
Auto Accompaniment
ending pattern.
AutoFill
Specifies whether a fill in
(Auto fill in)
should be inserted (on) or
not inserted (oFF) at the
end of the chord
progression.
Timing
Specifies the chord change
(Timing set)
timing during playback for
recorded chords. For
information about
differences in playback for
each setting value, see
"Timing Setting and Chord
Progression Playback"
(page E-60).
(3) Repeat steps (1) and (2) as required.
(4) After the settings are the way you want, press the R-15
(EXIT) button.
• This returns to the MP editor screen.
Setting
Range
*
oFF, Normal
,
Variation,
Intro
*
C
- B,
Cm - Bm
*
C
- B,
Cm - Bm
*
on
, oFF
*
Normal
, Half,
Double, 3/4,
3/2
Advertisement
Table of Contents
