Table of Contents
Advertisement
4.
Press the L-17 (PLAY/STOP) button.
• This will start playback of the audio file and cause the
L-17 (PLAY/STOP) button to change from flashing to
lit. The time counter also will start counting up.
• The following operations are supported during
playback.
To perform this
operation:
Fast forward
Hold down the L-15 (dFF) button or
rotate the dial to the right.
Fast backward
Hold down the L-14 (sREW) button
or rotate the dial to the left.
Pause
Press the L-16 (PAUSE) button.
Restart paused
Press the L-16 (PAUSE) button.
playback
Lower playback
Press the R-14 (–) button, which will
volume
display a volume setting screen.
Rotating the dial to the left while this
screen is displayed also will lower
playback volume.
Raise playback
Press the R-14 (+) button, which will
volume
display a volume setting screen.
Rotating the dial to the right while this
screen is displayed also will raise
playback volume.
Center cancel
Press the L-18 (PART SELECT)
button.
* Dial operation is supported only while the audio play screen
is displayed.
• Playback stops automatically when it reaches the end
of a song. To stop playback part way through, press the
L-17 (PLAY/STOP) button.
5.
To exit the audio play mode, press the C-2
(AUDIO PLAY) button.
• This returns to the mode screen (rhythm mode or song
sequencer mode) that was displayed before you
performed step 1 of this procedure.
• During audio record standby, you can exit the audio play
mode by pressing the R-15 (EXIT) button.
• During the above operation, you can press the C-2 (AUDIO
PLAY) button to exit the audio play mode.
Do this:
*
*
Recording and Playing Audio
■ About center cancel
Center cancel can be used to cut out the vocal part (which is
normally located in the center of the stereo field) from an
audio file stored to a memory card from your computer. How
successful center cancel is in cutting out the audio depends
on the audio file you are playing back.
Each press of the L-18 (PART SELECT) button toggles
between center cancel and normal (no center cancel)
playback. The current setting can be determined by checking
the graphic formed inside the level indicator as shown below.
Status
Playback standby
Normal
Center cancel
• When the MIC/INST parameter (page E-42) "Pan" setting is
"0" (initial default value), center cancel is applied to all
sound recorded from an external device connected to the
T-8 (MIC IN) jack or the T-5 (INST IN) jack.
Playback in
progress
E-127
Advertisement
Table of Contents
