Advertisement
8
Routing the Wire Harness
Parts needed for this procedure:
1
Wire harness
1
Clip tie
1
Plug
1
Fuse (30 A)
Procedure
There are 2 options for routing the wire harness.
One option is routing the harness under the control
panel as shown in the top image on
the clip tie in the lower hole on the side panel and the
plug in the top hole.
The other option, Box B in
drill a hole into the console. Install the clip tie in the top
hole on the side panel and the plug into the lower hole.
Important:
Use caution when drilling this hole;
electrical components and control cables are
located under the seat shroud.
A
B
Figure
11. Install
Figure
11, requires that you
Figure 11
Connect the ring terminal on the harness to the
grounding block and insert the fuse block connector
into an available fuse block connection
If a fuse block connection is not available, add a
fuse block to the fuse block grouping. Contact your
Authorized Service Dealer for more information.
1. Ground block
2. Wire harness
Lower the bed and connect the battery; refer to the
Operator's Manual.
g026280
g026280
8
(Figure
Figure 12
3. Fuse block
12).
g027556
Advertisement
