Advertisement
5. Secure the left and right seat belt anchor to the
front frame with 4 bolts (3/8 x 3/4 inch) and 4
nuts (3/8 inch) as shown in
Figure 8
6. Torque the 4 bolts (3/8 x 3/4 inch) to 37 to 45
N∙m (27 to 33 ft-lb).
7. Using the dimensions shown in
mark, and drill 2 holes in the top of the seat
shroud.
Important:
Use caution when drilling these
holes; electrical components and control
cables are located under the seat shroud.
g026313
Figure 9
1. 21 mm (2.1 cm)
8. Insert the mounting side of the receiver end of
each seat belt lock assembly into 1 of the newly
drilled holes in the seat base
Figure
8.
g026308
Figure
9, locate,
1
2
g026313
2. 51 mm (2 inches)
(Figure
10).
9. Mount the receiver end of each seat belt
assembly to each seat belt anchor with a bolt
(7/16 inch) and nut (7/16 inch) as shown in
Figure
10.
10. Torque the bolts to 67 to 83 N∙m (49 to 61 ft-lb).
7
Figure 10
g026314
Advertisement
