Power Supply Connections; Ground Connection - Memphis SRX1200.1V Instruction Manual

Use conventional stranded copper wire for all connections. Finish the ends of the wires at the amp and vehicle with
proper size terminals. Poorly made connections and/or inadequate wire size will generate excessive heat and may
lead to equipment failure.
12 Volt + Connection
Make the 12V+ connection directly at the positive battery post using the proper wire size and fuse listed below, The
fuse should be installed within 18" of the battery. This fuse is vital to protecting the vehicle from damage in the
case of a dead short.

Ground Connection:

Make ground connection directly to the chassis of the vehicle as close to the amp as possible. Make sure this
connection is made with the same wire size as used for the 12 volt connection. Ensure that all dirt, grease, paint
and coatings are removed prior to attaching the ground wire to chassis.
Remote Turn On
Remote turn on should be connected to the source unit's remote turn on lead or power antenna output wire. When
using the power antenna wire, make certain it does not lose power when any source other than the radio is
selected.
Power Connections

Power Supply Connections

Install the fuse at the battery last!
CAUTION
Model
SRX250.1V
SRX500.1V
SRX750.1V
SRX1200.1V
CAUTION
Amp Kit
8
4
4
4