Table of Contents
Advertisement
Collector Installation
Install Mount Plate
1. Install the adapter plate (A, Figure 19) onto the
mount plate (B) and secure with the 3/8-16 x 1"
bolts (C) and 3/8-16 nylock flange nuts (D).
2. Install the mount plate onto the bumper.
3. Install the mount spacers (E) between the adapter
plate and mount plate, as shown, and loosely
secure with the 3/8-16 x 2-1/2" bolts (F) and 3/8-
16 nylock flange nuts (D).
4. Install the 3/8" U-bolts (G) on the bottom bumper
tube and through the mount plate. Loosely install
the 3/8-16 nylock flange nuts (D).
5. Center the mount plate, side-to-side, on the
bumper tubes and tighten hardware securely.
6. Attach the back plate (A, Figure 20) to the mount
frame (B) using carriage bolts, flat washers, and
nuts. Use two 5/16-18 x 3/4" carriage bolts (D)
in the top two holes, and two 5/16-18 x 1-1/4"
carriage bolts (E) in the bottom holes.
7. Install the cover latch (H) and reinforcement plate
(G). Secure with two 5/16-18 x 3/4" bolts (F), and
5/16-18 serrated flange nuts (J).
8. Mount the back plate to the support assembly and
secure with the long hitch pin (K) and hair pin clip
(L).
E
B
C
F
D
Figure 19. Install Mount Plate
A. Adapter Plate
B. Mount Plate
C. 3/8-16 x 1" Bolts
D. 3/8-16 Nylock Flange Nuts
E. Mount Spacers
F. 3/8-16 x 2-1/2" Bolts
G. 3/8" U-Bolts
A
D
G
B
A
C
I
H
J
L
Figure 20. Install Back Plate
A. Back Plate
B. Mount Frame
C. 5/16-18 Nylon Lock Nuts
D. 5/16-18 x 3/4 Carriage Bolts
E. 5/16-18 x 1-1/4 Carriage Bolts
F. 5/16-18 x 1 Bolts
G. Latch Reinforcement Plate
H. Cover Latch
I. 5/16" Flat Washers
J. 5/16-18 Serrated Flange Nuts
K. Hitch Pin
L. Hair Pin Clip
INSTALLATION
D
E
E
F
G
K
15
Advertisement
Table of Contents
