Table of Contents
Advertisement
Reinstall the Spindle Belt
Refer to the belt removal instructions on in
Remove the Spindle Belt and reverse the order for
reinstalling the belt.
Install the Deck Guard
1. Install the new deck guard onto the mower deck
and secure with the hardware previously removed
(see Figure 14).
Blower Installation
1. Install the blower onto the mower deck. Refer to
Figure 15 for the position of the pins w/ lanyards
in relationship to the chute mount bracket on the
mower deck. The pins w/ lanyards fit into the
same holes that the chute mount rod was installed.
2. Install the blower drive belt. Refer to Figure 16
for the proper belt routing. It may be required to
loosen the idler pulley mounting hardware to get
the belt past the belt keeps.
NOTE: The gray area denotes the flat side of the belt.
V-side of belt must contact v-groove pulleys, flat side
of belt must contact flat pulleys.
3. Check the belt tension by measuring the distance
from the center of the v-idler pulley (A, Figure
17) mounting bolt and the blower housing. This
should measure between 3 - 3-3/8" (7,6 - 8,6 cm).
4. If measurement falls outside of this range, you
must move the idler pulley (B) either forward or
back to achieve the proper belt tension.
NOTE: If pulley position needs to be adjusted, make
sure that it is reinstalled in the same row of holes as
determined in the blower assembly (Step 7, page 9).
Figure 14. Install Guard
Figure 15. Install Blower On Deck
Figure 16. Install Belt
B
A
Figure 17. Check Belt Tension
A. V-Idler Pulley
B. Idler Pulley
INSTALLATION
3" - 3-3/8"
(7,6 - 8,6 cm)
13
Advertisement
Table of Contents
