Page 1
Instruction Sheet JH Premium Steel Hydraulic Jacks Document Number Document Revision Document Revision Date L2009 11/2017 IMPORTANT RECEIVING INSTRUCTIONS: Visually inspect all components for shipping damage . If any shipping damage is found, notify carrier at once . Shipping damage is NOT covered by warranty . The carrier is responsible for all repair or replacement costs resulting from damage in shipment .
Page 2
ENERPAC CANNOT BE HELD RESPONSIBLE FOR DAMAGE OR INJURY RESULTING FROM UNSAFE USE OF PRODUCT, LACK OF MAINTENANCE, OR INCORRECT PRODUCT AND SYSTEM APPLICATION . Contact Enerpac when in doubt as to applications and safety precautions . WARNING JH jacks are NOT equipped with a stop ring to Red Line retain the plunger.
Page 3
2 . Place jack on its side with fill plug facing up . Remove fill plug . 3 . Slowly add Enerpac hydraulic fluid . Do not fill reservoir completely . Fluid level should be below fill plug when jack is upright .
Page 4
4 . Periodically lubricate the jack pump beam . TROUBLESHOOTING The following is intended as an aid in determining if a problem exists . DO NOT disassemble the jack . For repair service, contact the Authorized Enerpac Service Center in your area . Problem Possible Cause...
Need help?
Do you have a question about the JH Premium and is the answer not in the manual?
Questions and answers