Table of Contents
Advertisement
Transit Dropside 2014:11-12 Seat Transit
Tailboard
The tailboard is manufactured from tough lightweight extruded aluminium,
secured by two latches per side locking the tailboard to the rear corner pillars.
To open the Tailboard:
Remove sheeting if load is sheeted, visually check the load is not exerting force
on the Tailboard.
Push against the top of the Tailboard with one hand. With the other hand release
one latch by pulling the handle up to approximately 90° from the vertical,
continue pushing the handle up until almost vertical and the latch is released.
Repeat the operation for the other latch whilst supporting the Tailboard. Then
lower it carefully. Do not drop the Tailboard or damage may possibly result.
Loads exerting force on the Tailboard could cause injury if not
removed prior to opening the board.
12
28/11/14
10:52
Controls
Tailboard closed and latched
Tailboard unlatched ready to open
WARNING
Page 15
Advertisement
Table of Contents
