Core PowerBox Systems V 2.80 Manual page 82

3.7 Servo Cut-OFF
This feature provides a very easy means of switching a servo output to a fixed, previously defined value. An example of this might
Servo Cut-
be a motor arming switch, or a fixed, pre-defined nosewheel position when the undercarriage is retracted. Select the
Off +
menu, then press in order to create a new cut-off function. At this point select the servo which you wish to move to a fixed,
pre-defined position, then press OK.
transmitter control
First select a by briefly pressing the blank field (three dashes) under Control; press Control again at the next
screen. You can now select a switch or linear control as transmitter control by operating it.
Yet another option is to use the output of a previously defined
logical switch OK
in turn as a transmitter control input. Press
when you have made your selection.In the following section
you will see your transmitter control on the left. Depending on
whether you have selected a linear input or a switch, you will
see one of these screens:
22
PowerBox-Systems − World Leaders in RC Power Supply Systems