Installing The Product - Beko HIYG 64225 SXO User Manual

5 Installation
If there is a built-in oven installed under
the hob;
• Gas hose must be routed in a way that it will not touch the
oven, sharp edges or corners beneath the hob, or will not be
kinked or twisted.
If you will make the gas connection from left hand side when
viewed from your position, fix the hose with clamps.
1 Bottom view
2 Hose tip
3 Hose
4 Clamp
5 Oven

Installing the product

1. Remove burners, burner caps and grills on the hob from
the product.
2. Turning the hob upside down, place it on a flat surface.
3. In order to avoid the foreign substances and liquids penetrate
between the hob and the counter, please apply the putty
supplied in the package on the contours of the lower housing
of the hob but make sure that the putty does not overlap.
4. Fill the corners by forming bends at the corners as illustrated
in the figure. Form as much bend as required to fill the gap in
the corners.
16 / EN
C
Make sure that the skirting sections on the
lower housing of the hob are filled with putty.
5. Turning the hob again, align and place it on the counter.
6. You can secure your hob to the counter by using the
clamp and the screws supplied.
Thickness of the counter must be at least 40 mm.
When installing the hob onto a cabinet, a
C
shelf must be installed in order to separate
the cabinet from the hob as illustrated in
the above figure. This is not required when
installing onto a built-under oven.
For example, if it is possible to touch the bottom of the product
since it is installed onto a drawer, this section must be covered
with a wooden plate.
min. 25 mm
For counters with a thickness of 40-50 mm, install the clamps
as shown below. You must leave a ventilation opening on the
remaining part in order to provide ventilation at the lower part
of the hob. In addition to being necessary for component tem-
peratures, this process is also compulsory for the TC burner to
take in air from the bottom. It can be "100 cm2 at least".
Built-in hob / User manual