Electrical Connection - Beko HIYG 64225 SXO User Manual

5 Installation
5.4 Rooms that do not have openable
doors and/or windows that open
directly to the outer envi-ronment
If the room where the appliance is installed does not have a door
and/or a window that opens directly to the outer environment,
other products shall be sought that definitely provide a fixed
nonadjustable and non-closable ventilation opening which
meets the total minimum ventilation opening requirements for
the total gas consumption of the appliance as indicated in the
above table.Also the appropriate building regulations advise
should be followed.
Where a room or internal space contains more than one gas
appliance, additional ventilation area shall be provided on top
of the requirement given in the table above. Size of additional
ventilation area shall be appropriate to regulations of other gas
appliances.
There should also be a minimum clearance of 10mm on the
bottom edge of the door that opens to the inner environment
in the room where the appliance is instal-led.You must ensure
that items such as carpets and other floorcoverings etc., do not
affect the clearance when the door is closed.
The cooker may be located in a kitchen, kitchen/diner or a bed-
sitting room, but not in a room containing a bath or a shower.
The cooker must not be installed in a bed-siting room of less
than 20m3.
5.5 Do not install this appliance in a
room below ground level unless it is
open to ground level on at least one
side

Electrical connection

Connect the product to a grounded outlet/line protec-ted by a
fuse of suitable capacity as stated in the
"Technical specifications" table. Have the grounding installation
made by a qualified electrician while using the product with
or without a transformer. Our com-pany shall not be liable for
any damages that will arise due to using the product without a
grounding installa-tion in accordance with the local regulations.
14 / EN
DANGER:
The product must be connected to the mains
supply only by an authorised and qualified
A
person. The product's warranty period starts
only after correct installation.
Manufacturer shall not be held responsible
for damages arising from procedures carried
out by unauthorised persons.
DANGER:
The power cable must not be clamped, bent
A
or trapped or come into contact with hot
parts of the product.
A damaged power cable must be replaced by
a qualified electrician. Otherwise, there is risk
of electric shock, short circuit or fire!
• Connection must comply with national regulati-ons.
• The mains supply data must correspond to the data specified
on the type label of the product. Type label is at the rear housing
of the product.
• Power cable of your product must comply with the values in
"Technical specifications" table.
DANGER:
A
Before starting any work on the electrical
installation, disconnect the product from the
mains supply.
There is the risk of electric shock!
C
Power cable plug must be within easy reach
after installation (do not route it above the
hob).
Plug the power cable into the socket.
Built-in hob / User manual