Table of Contents
Advertisement
3
Installation
3.6 Installing the product
1. Remove burners, burner caps and grills on the
cooktop from the product.
2. Turning the cooktop upside down, place it on a
flat surface.
3. In order to avoid the foreign substances and
liquids penetrate between the cooktop and the
counter, please apply the putty supplied in the
package on the contours of the lower housing
of the cooktop but make sure that the putty
does not overlap.
4. Fill the corners by forming bends at the corners
as illustrated in the figure. Form as much bend
as required to fill the gap in the corners.
C
Make sure that the skirting sections
on the lower housing of the cooktop
are filled with putty.
5. Turning the cooktop again, align and place it on
the counter.
6. You can secure your cooktop to the counter by
using the clamp and the screws supplied.
1. Cooktop
2. Putty
3. Installation clamp
4. Counter
Thickness of the counter must be at least 40 mm.
18 / EN
When installing the cooktop onto a
cabinet, a shelf must be installed in
C
order to separate the cabinet from
the cooktop as illustrated in the
above figure. This is not required
when installing onto a builtunder
oven.
For example, if it is possible to touch the bottom
of the product since it is installed onto a drawer,
this section must be covered with a wooden plate.
min. 25 mm
For counters with a thickness of 40-50 mm, install
the clamps as shown below.
You must leave a ventilation opening on the re-
maining part in order to provide ventilation at the
lower part of the cooktop. In addition to being nec-
essary for component temperatures, this process
is also compulsory for the TC burner to take in air
from the bottom. It can be "100 cm² at least".
Built-In Hob / User Manual
Advertisement
Table of Contents
