Beko HIYG 64225 SXO User Manual page 15

5 Installation
Gas connection
DANGER:
Product can be connected to gas supply
system only by an authorised and qualified
A
person or technician with licence.
Risk of explosion or toxication due to unpro-
fessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures carried
out by unauthorised or unlicensed persons.
DANGER:
A
Before starting any work on the gas installa-
tion, disconnect the gas supply.
There is the risk of explosion!
• Gas adjustment conditions and values are stated on labels
(or ion type label).
C
The gas type of your product is stated on
type label placed bottom of hob.
Connecting the gas hose For NG
• Natural gas installation must be prepared before installing
the product.
• There must be a pipe (Piping advised to be buyed from a
licensed installer), must comply with local gas standard, at the
outlet of the ins-tallation for the natural gas connection of your
product and the tip of this pipe must be closed with a blind
plug. Service Representative will re-move the blind plug during
connection and con-nect your product by means of a straight
connec-tion device (coupling).
• Make sure that the natural gas valve is readily accessible.
• If you need to use your product later with a different type of
gas, you must consult the Aut-horised Service Agent for the
related conversion procedure.
Connecting the gas hose For LPG
• Have your product connected in a way that it will be close to
the gas connection and not gas lea-kage will exist.
Built-in hob / User manual
• Plastic hose to be used must not be longer than 125 cm.
• Install the clamp to the hose. Soak one end of the hose (15
mm inner diameter) into boiling water for one minute to soften
it.
• Than, slip the softened end of the hose comple-tely onto
the sharp hose tip of your product. Fi-nally, tighten the clamp
completely with a screwdriver.
• Repeat the same procedure for the other end of the hose and
complete the gas cylinder connec-tion.
• Never forget to make the gas leakage control.
DANGER:
A
Risk of explosion and suffocation! Do not
keep LPG cylinders in home.
• If you need to use your product later with a different type of
gas, you must consult the Aut-horised Service Agent for the
related conversion procedure.
Leakage control at the connection point
• Make sure that all knobs on the product are turned off. Make
sure that the gas supply is open. Prepare soapy foam and apply
it onto the con-nection point of the hose for gas leakage control.
• Soapy part will froth if there is a gas leakage. In this case,
inspect the gas connection once again.
C
Never use a match or lighter to make the gas
leakage control.
15 / EN