Table of Contents
Advertisement
Note: Do not damage the ventilators of the bodycooler during this action!
Connect all cables (X1, X2, X3 and X5 from Fig.1) and assemble the swivel plates (Fig.2:D).
Connect the power supply cable (Fig.1:PS) to the power supply X4. This needs to be done like is
indicated in Fig.8 (for 230V)
3 x 2,5 mm
2
Fig. 8
In the end, the ballast tray (Fig.1:E) needs to be secured with the two already assembled screws in
the left post (Fig.9:P)
Fig. 9
Attach the side covers (Fig.11:L1 and L2) on both sides of the bed, by sliding the top of the cover into
the synthetic end profile and placing it over the metal plate on the backside (Fig.12:K).Fasten both
side covers with 3,9x9,5 screws to the metal backside like is indicated (arrows) in Fig.10.
10
Advertisement
Table of Contents
