Ricoh Caplio R40 User Manual page 129

To transfer images in Mass Storage Mode, follow the
steps below:
1.
Set [USB CONNECTION] to [MASS STR] on the SETUP
menu.
2.
Make sure that the camera is off.
3.
Connect the supplied USB cable to a USB port on your
computer.
4.
Connect the USB cable to the USB
terminal on your camera.
Your camera turns on.
Your computer automatically reads the file
necessary for recognizing the camera as a
drive.
After this preparation, the camera is displayed as a drive in [My
Computer] (Windows) or Desktop (Macintosh).
5.
From the displayed drive,
copy the file to the desired
location.
The figure at right shows the folder
configuration in the drive.
The contents of the internal memory
are displayed under the drive name
[RICOHDCI].
Caution
• Do not disconnect the USB cable during data transfer.
• If a file with the same name already exists at the destination, it is overwritten. If you do not
want the file to be overwritten, rename the file or transfer data to another folder.
Note
When an SD memory card is loaded, its files are displayed. Otherwise, files in the internal
memory are displayed.
Example of the display in
Windows XP
127