Setting Up The Nshield Edge; Power Saving Options; Connecting An Nshield Edge - Entrust nShield Edge Installation Manual

6. Setting up the nShield Edge

6.1. Power saving options

Do not use the power-saving features of your computer when the

nShield Edge is connected. If your computer goes into standby or sleep
mode, the hardserver restarts automatically.
If your computer has power saving features enabled, do the following:
Windows
1. From the Power Options section of the Control Panel, select Power Option >
Change plan settings.
2. For Put the computer to sleep, select Never .
Linux
Set power options to never put computer to sleep.

6.2. Connecting an nShield Edge

Do the following:
6.2.1. Windows
Connect the nShield Edge to your computer, using the supplied USB cable.
If your operating system detects the nShield Edge automatically, allow it to finish.
A message appears, reporting that Windows is stopping and restarting the hardserver.
This takes approximately 30 seconds. Do not click Close.
nShield® Edge Installation Guide 14 of 29