Intel Braswell Series Technical Manual page 41

Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
make further settings in 'SmartFAN Configuration'.
 SmartFAN Configuration
Press [Enter] to make settings for SmartFAN Configuration:
CPUFAN / SYSFAN1 Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 full speed temperature. Fan will run
at full speed when above the preset temperature.
CPUFAN / SYSFAN1 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1 full speed duty. Fan will run at full
speed when above the pre-set duty.
CPUFAN / SYSFAN1 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 idle speed temperature. Fan will run
at idle speed when below the pre-set temperature.
CPUFAN / SYSFAN1 Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN1 idle speed duty.. Fan will run at idle
speed when below the pre-set duty.
Shutdown Temperature Configuration
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [65
o o
[80 C/176 F]; [85
o o
C/185 F].
o o
C/149 F]; [70
36
o o o
C/158 F]; [75 C/167
o
F];