4.4 Check Pins
The M34282T5-OPT has the check pins listed in Table 4.4.
Table 4.4 Check pins
TP1
TP2
TP4
TP5
4.5 Connectors
Table 4.5 lists the functions of connectors of the M34282T5-OPT. Figure 4.3 shows the connector
locations.
Table 4.5 Connector list
Connector
Figure 4.3 Connector locations
Pin
V
Outputs power voltage +3 V to the evaluation MCU.
DD
X
Outputs system clock input to the evaluation MCU.
IN
Outputs "H" level when executing WRST instruction.
WRST
By observing pulse width, it is possible to confirm the initializing cycle of the
watchdog timer.
GND
GND
J1
Connects the evaluation MCU bus.
J2
Connects the monitor CPU bus.
J3
Connects the target system (40-pin).
J4
Connects external trigger signal (2-pin).
J5
Connects the oscillator board (4-pin).
Description
Description
( 17 / 38 )