(1) Undo 5 screws (S3).
[ NOTE ] For non-MCR type models, undo 3 screws (S3).
(2) Disconnect the connectors (3 places).
[ NOTE ] As the lead wires of the Trigger switch are thin, handle them carefully.
(3) Release the connector lock and disconnect the FPCs (4 places).
(4) Disconnect the W-LAN antenna, WAN antenn and GPS cable.
[ NOTE ] The WAN antenna is stuck with double-sided tape.
(5) Remove the I-CASE-UNIT while paying attention to the FPC and cables.
– 70 –
FPC (Touch Panel)