Table of Contents
Advertisement
1. Safety instructions
WARNING: CAREFULLY READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• Carefully read the manual before the charger is installed and operated; retain the manual in a safe place for
future reference.
• The charger must not be installed or operated by any of the following persons, unless they are under strict
instruction and supervision:
a. Anyone who lacks the appropriate knowledge, experience or competence, required for safe installation
and/or usage.
b. Anyone with compromised/reduced physical, sensory or mental capabilities, which may effect safe
installation and/or usage (including children).
• Charger installation and operation
a. Install the charger in a location with good natural airflow/ventilation and sufficient unobstructed space
around it; refer to the the 'Installation' section for more detail.
b. Install the charger on a non-flammable substrate and ensure there are no heat-sensitive items in the
immediate vicinity; it is normal for the charger to become hot during operation.
c. Install the charger in a location where it is protected from environmental conditions such as water, high
moisture and dust, and also located well away from any flammable liquids or gasses.
d. Do not install or place/operate the charger on top of the battery, directly above the battery, or in a sealed
compartment with the battery; batteries can emit explosive gasses.
e. Do not cover or place any other items on top of the charger.
• Battery installation and charging
a. Install and charge the battery in a location with good natural airflow/ventilation.
b. Ensure that there are no ignition sources near the battery; batteries can emit explosive gasses.
c. Battery acid is corrosive; if battery acid comes into contact with skin immediately rinse with water.
d. Do not charge non-rechargeable batteries or Li-ion batteries if the battery temperature is below 0°C.
• Battery DC connections
a. Ensure that the DC system is fully shut down/isolated prior to disconnection of any existing cabling
and/or new connections are made to the battery/DC system.
b. Use flexible multi stranded copper cable with sufficient cross sectional area, inline with an appropriate
fuse or circuit breaker; refer to the 'Installation' section for more detail.
• Mains supply AC connection
a. AC connection to the mains supply must be in accordance with local electrical regulations. The charger
must be plugged into an earthed AC mains power outlet.
b. Do not operate the charger if the AC power cable is damaged, contact a service agent.
• Charger setup
a. Refer to the battery manufacturers instructions and specifications to ensure the battery is suitable for
use with this charger and confirm the recommended charge settings.
b. The integrated charge modes (selected via the MODE button or VictronConnect app) combined with
adaptive charge logic are well suited for most common battery types; such as flooded lead-acid, AGM,
Gel and LiFePO4.
If necessary, advanced configuration with user defined settings is possible using the VictronConnect
app and a Bluetooth enabled device (such as a mobile phone or tablet).
Page 1
Phoenix Smart IP43 Charger
Safety instructions
Advertisement
Table of Contents
