Appliance Setup - Criterion CUF154WD1W Use & Care Manual

Hide thumbs Also See for CUF154WD1W:
Table of Contents

Advertisement

Appliance Setup

This Use & Care Guide provides specific
operating instructions for your model. Use the
unit only as instructed in this Use & Care
Guide. Before starting the appliance, follow
these important setup steps.
Installation
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• For the most efficient operation, the
appliance should be located where
surrounding temperatures will not exceed
110°F (43°C). Temperatures of 32°F (0°C)
and below will NOT affect appliance
operation. Additional compressor heaters
are not recommended.
• Allow space around the unit for good air
circulation. Leave a 1-inch (25.4 mm)
space at the back and on top and a
3/8-inch (9.5 mm) space on the sides of
the appliance for adequate circulation.
Leveling
The appliance must have all bottom corners
resting firmly on a solid floor that is strong
enough to support a fully loaded appliance.
It is Very Important for the appliance to be
level in order to function properly. If not
level, the door may be misaligned and not
close or seal properly, causing cooling,
The appliance is equipped with adjustable
frost, or moisture problems.
front leveling feet. Turn the foot clockwise
to heighten (H) the side of the unit. Turn
counterclockwise to lower (L) the side. Adjust
each side as needed until front of unit is level.
Also adjust so that front of unit is 1/4˝ higher
than back, so that door stays closed.
Cleaning
• Wash any removable parts, the
appliance interior, and exterior with mild
detergent and warm water. Wipe dry.
Do not use harsh cleaners on these
surfaces.
• Do not use razor blades or other sharp
instruments, which can scratch the
appliance surface when removing
adhesivelabels. Any glue left from the
tape can be removed with a mixture of
warm water and mild detergent, or
touch the residue with the sticky side of
tape already removed. Do not remove
the serial plate.
Energy Saving Ideas
for Freezer Mode
• Let hot foods cool to room temperature
before placing in freezer. Overloading the
freezer forces the compressor to run
longer. Foods that freeze too slowly may
lose quality or spoil.
• Be sure to wrap foods properly, and
wipe containers dry before placing
them in the freezer. This cuts down on
frost build-up inside the freezer.
• Do not line freezer shelves and bins
with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air
circulation, reducing freezer efficiency.
• Organize and label food to reduce lid
openings and avoid extended searches.
• Remove as many items as needed at one
time, and close door as soon as possible.
5
The freezer should be
located in the coolest area of
the room, away from heat
producing appliances or
heating ducts, and out of
direct sunlight.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cuf179wd1wCuf208wd1w

Table of Contents