Advertisement
FILLING & REFILLING
1. Open the Top Cover as the above
Instruction. Using another container,
fill water into the Inner pot until the
FULL mark is reached. Do not over fill
as hot water may splash out during
boiling.
2. Close top cover, ensure lid is se-
cured by pressing firmly down till
BOIL WATER
1. After power is connected, water will
start to boil immediately.
Do not open top cover when water is
boiling.
Do not fill hot water when boiling.
Be caution of steam emitting from
steam vent.
KEEP WARM
1. The Keep Warm function will acti-
vate and the indicator light (green)
will turn ON.
water had been added or if you want
to reboil water in the pot up to 100
degree again.
Setting the KEEP WARM Tempera-
ture
Press
choose what temperature you like and
you can change this setting at any
time.
You may select from four temperature
0
0
settings 98
, 85
the KEEP WARM indicator light will be
lit during this phase.
TEMPERATURE SETTING CHART
Suitable for instant food
0
98
C
cooking, hot beverage such
as coffee or tea. (always set
back to 85
0
85
C
Most suitable for tea serving
and to save electricity
0
60
C
Suitable for instant milk
formulas and taking medica-
tion and to save electricity.
Cool
Suitable for cool water save
down
electricity.
button if cold
0
, 60
, cool down,
after usage.)
THREE WAY WATER OUTLET
1. AIR PUMP
Put the cup near water outlet,
Press< pump lid>. (No need power)
2. AUTO DISPENSE
to dispense water.
3. CUP SWITCH
b) Use the cup mouth to touch <cup
switch>water outlet at once.
As an added safety feature, the Air pot
will be automatically locked after 10
pensing function is not used.
The dispensing function will be NOT
operated if power cord is pulled out.
CAUTION:
Always keep the lid away from you as
there is hot steam trapped under the
lid.
Do not press the dispensing button
when the inner water reservoir is
empty.
(Doing so can cause damage.)
You cannot dispense hot water by
Auto Dispense button or the Cup
Switch if the pot is unplugged.
RE-BOIL FUNCTION
boing indicator light will lit
2. After RE-BOIL is completed, the
KEEP WARM indicator light will lit
Re-boil will not function if there is
insufficient water inside.
Press the RE-BOIL button immedi-
ately after the water had just
reached boiling level will have no
effect as the water is already at
100 .
AUTO CUT-OFF
1. When the water boil dry, the elec-
tric air pot will automatically switch
itself off.
2. The auto CUT-OFF function will also
operate when:
The power is switched ON, but
water had not been filled.
Water level is below the MIN water
level indicator.
CLEANING
Switch OFF the main switch, unplug
the cord from the appliance and allow
unit to cool temperature. Pour out the
remaining water.
Clean the INNER POT with soft
sponge.
5
-
button
Re-
Advertisement
