Mounting the Mast on Brick or
Poured Concrete
IMPORTANT Considerations
•
The wall anchors used must have a strength of at least 300
pounds of pull-out pressure. B4015 or equivalent double-
expansion anchors are recommended.
•
Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
Mounting Instructions
1. Hold the mounting foot in position on the mounting surface.
2. If you are mounting on a vertical or sloped surface, use a level to
ensure that the center line is vertical.
Step 1: Hold the mounting
foot in position.
3. Mark the four outside holes on the mounting foot.
4. Remove the foot and drill four (4) 1/2" holes in the locations
you marked.
Mounting the Mast on Brick or Poured Concrete
Materials Needed
4
double expansion anchors
4 machine screws
4
5 /16
" washers
Step 2: Make sure the mounting
foot is level.
Tools Needed
• Electric drill with
1/2" masonry bit
• Bubble level
• Screwdriver
• Hammer
• 7/16" wrench
• Pencil
level on center
line of template
Level
Not Level
DANGER
AVOID Power Lines!
When following these
instructions, take
extreme care to avoid
contact with overhead
power lines, electric
lights, and power
circuits. Contact with
power lines, electric
lights, or power circuits
may be fatal. It is
recommended that the
dish be located more
than 20 feet from
overhead power lines.
Mounting the Mast 19