Leveling Front-To-Back; Final Dish Assembly - RCA Satellite TV Antenna Installer's Manual

Leveling Front-to-Back

1. Loosen the two bolts securing the mast to the mounting foot so
the mast moves freely.
2. Place a bubble level on the mast as shown in the figure. Move the
mast so the bubble is centered in the level's window.
Level
Rotate mast as needed
Adjustment
3. Tighten the two bolts securing the mast to the mounting foot.

Final Dish Assembly

1. Place the dish-LNB arm assembly on top of the mast (or pole).
Step 1: Place the dish assembly
on the mast or pole
2. Find the length of RG-6 coaxial cable with messenger (ground)
wire that will extend from the satellite dish to the cable's point of
entry into the building.
If your total RG-6 coaxial cable length from the dish to the receiver
is more than 112 feet, you may need an additional installation
component, such as a line amplifier, to compensate for the longer
cable length.
Not Level
Adjustment
Step 2: Verify that the mast is level front-to-back.
Sony Step 1: Loosen the mast clamp and lower
reflector onto the mast. Tighten the
clamp screws.
Level Not Level
Rotate mast as needed
Final Dish Assembly
Final Installation 29