Table of Contents
Advertisement
Mounting the Mast on Solid Wood
8. Install two 5/16" x 3" lag screws into the two center holes on the
mounting foot. Securely tighten the screws.
9. Put washers on the 5/16" x 2" lag screws, insert the screws into
the four outside holes and securely tighten them.
Steps 8 & 9: Inserting the lag screws.
10. Go on to the next section, "Final Installation," to complete the
installation process.
Installing a Spacer
When the mounting foot spans two pieces of siding, it should be
positioned so most of the foot is on the top board. A spacer should be
installed to help hold the bottom of mounting foot in place. The spacer
can be made of either solid wood or plastic.
lap board
18 Mounting the Mast
5/16" x 2" Lag Screws
5/16" x 3" Lag Screws
(For Sony Dish Installations
use (2) 3" x 1/4" Lag Screws)
5/16" x 2" Lag Screws
spacer
Advertisement
Table of Contents
