Table of Contents
Advertisement
Allow a clearance
of at least 10
inches (254 mm)
(254 mm)
propeller from damaging the transducer when it is turned.
•
Do not mount the transducer behind any hull fittings, intakes, or
other parts which extend from the hull. These may cause turbulence
or air bubbles.
•
The bracket has a quick-release mechanism. This prevents damage
by allowing the transducer to flip up if it hits any debris or the bottom.
See Fig. 2-4. Allow enough clearance above the transducer so that it
can swing upward completely. This is about 10" (254 mm) measured
from the bottom of the transom.
Installation
10"
Transducer in
released position
Fig. 2-3
Transducer
Mounted on
Transom
Fig. 2-4
Transducer
Bracket,
Side View
7
Advertisement
Table of Contents
