Table of Contents
Advertisement
No.
Qty
1
1
6
2
11
2
7
1
Table 1 Main Parts of the RSU and Mounting Hardware
1. Hold the bracket up against the pole, and slide two metal straps through the top and
bottom of the bracket as shown in Figure 7. Note: This example depicts installation of
the bracket to a vertical pole [Figure 7].
2. Wrap the metal straps around the pole and lock them and lightly tighten the straps
screws using a wrench. The screws should be lightly tightened to prevent the bracket
from sliding down the pole.
2.1.2 Installing the Mounting Bracket to the RSU
1. Align the mounting bracket to the rear of the RSU such that the holes of the mounting
bracket align with the holes in the ears of the RSU.
2. Align the M8 mounting bolt along with the lock washer and insert into the threaded hole
of the RSU [Figure 7].
3. Using a wrench, tighten the bolt to the RSU securely. Tension?
4. At this point, the RSU should be securely coupled to the mounting bracket but may be a
bit loosely coupled to the pole.
5. Place the RSU to its final desired position and further tighten the metal straps so that
the RSU does not slide on the pole. Ensure that the strap screws are tight enough to
prevent the RSU from moving or sliding. Tension ?
6. At the end of this step, the RSU, bracket and strap should resemble the illustration in
Figure 8. Note that a vertical pole hasn't been depicted here.
Savari Inc., Confidential
Copyright © Savari, Inc. 2017
Description
Roadside Unit main enclosure
Mounting Bolts
Mounting Straps
Mounting Bracket
9
StreetWAVE™SW-1000™ Installation Guide
Advertisement
Table of Contents
