Advertisement
INSTALLATION STEPS
1. Cabinet Mounting
In a clean, dry area, mount the backbox using the
four holes provided in the back surface of the cabinet
(Figure 2).
Figure 2: Typical mounting hole locations
2. Module Installation
There are two methods for installing a module in the
rear position of a chassis. Method one is for installa-
tion of a rear module only, when no module will be in-
stalled in front of it. Refer to Figure 3 for instructions.
Method two is for installation of a rear module when
another module will be installed in the chassis position
in front of it. Refer to Figures 4a and 4b for method
two. All necessary screws and standoffs are supplied
with the modules.
2
1
Figure 3: Installation of rear module only, method one
Step 1: Insert the bottom of the IDP-Monitor-10 module
down into a rear slot on the chassis.
Step 2: Carefully swing the upper edge of the board
back towards the back of the chassis until it
touches the two standoffs.
Step 3: Align two 4-40 screws with the two standoffs
and tighten.
Step 4: Address and wire the modules according to the
instructions in this manual.
The steps in Figures 4a and 4b describe and illustrate mod-
ule installation when the rear chassis position and the posi-
tion in front of it will be filled. Front position installation
is possible only if the rear position is filled with a module.
K200-14-00
Backbox
Mounting
Holes
Figure 4a: Installation of IDP-Monitor-10 module in a
C0235-00
Step 1: Insert the bottom edge of the IDP-Monitor-10
Step 2: Carefully swing the upper edge of the board
Step 3: Align the long standoff with the short stand off
3
Figure 4b: Installation of IDP-Monitor-10 module in
Step 1: Insert the bottom edge of the IDP-Monitor-10
Step 2: Carefully swing the upper edge of the board
C0237-00
Step 3: Align two 4-40 screws with the two standoffs
Step 4: Address and wire the modules according to the
2
firealarmresources.com
1
rear chassis position, method two
module down into a rear slot of the chassis.
towards the back of the chassis until it touches
the short standoff attached to the chassis.
and tighten.
2
1
front chassis position
module down into a front slot of the chassis.
towards the back of the chassis until it touches
the 1
1
⁄
˝ (31.75mm) standoffs installed on the
4
rear module.
and tighten.
instructions in this manual.
C0225-00
3
C0226-00
I56-2731-003
Advertisement
