Table of Contents
Advertisement
CAUTION
For continued safety, replace with a lamp assembly of the same type.
Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can
become very hot.
Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1
Check the number of lamp to be replaced on Lamp Status
Display.
Turn off the projector and disconnect the AC Power Cord. Allow
2
the projector to cool down for at least 45 minutes.
3
Remove the two screws on the Lamp Cover and press the
button to open the Lamp Cover. (See right figure.)
4
Loosen the two screws and pull out the Lamp Assembly to be
replaced by grasping the handle.
5
Replace the Lamp Assembly with a new one and tighten the two
screws. Make sure the Lamp is set properly
6
Replace the Lamp Cover and tighten the two screws.
Connect the AC Power Cord to the projector and turn the
7
projector on.
8
Reset the Lamp Replacement Monitor Timer. (Refer to the
section "Lamp Replacement Monitor Timer" on page 41.)
NOTE : Do not reset the LAMP REPLACEMENT MONITOR
TIMER when the lamp is not replaced.
CAUTION : Do not operate the projector while any of lamps is removed.
It may result in malfunctions, fire hazard, or other
accidents.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following
information to the dealer.
Model No. of your projector
Replacement Lamp Type No. : POA-LMP29 (Proxima Lamp No.: LAMP-XXX)
Follow these steps to clean the projection lens:
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
1
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
Lightly wipe the cleaning cloth over the lens.
2
3
When the projector is not in use, replace the lens cover.
LAMP REPLACEMENT
: Pro AV 9350
(Service Parts No. 610 284 4627)
CLEANING THE PROJECTION LENS
LAMP
COVER
SCREWS
LAMP 1
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows the case of replacing the LAMP 2.
APPENDIX
BUTTON
SCREWS
LAMP 3
LAMP 4
LAMP 2
45
Advertisement
Table of Contents
