Table of Contents
Advertisement
The normal picture level is preset on this projector at the
factory and can be restored anytime you press the NORMAL
button (located on the Side Control or on the Remote Control
Unit). The "Standard" display will be displayed on the screen
for a few seconds.
PICTURE POSITION ADJUSTMENT
The position of the image can be adjusted vertically and horizontally through PICTURE POSITION
ADJUSTMENT.
1
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
POSITION and press the SELECT button. The PICTURE
POSITION dialog box will appear.
2
Select the arrow to the direction (described as
that you want to adjust by pressing the POINT UP/DOWN/
LEFT/RIGHT buttons, and then press the SELECT button.
Each of the keys operates as follow.
Reset
Recalls the setting data previously set.
Stored
Stores the setting data in the memory.
Quit
Closes the PICTURE POSITION Menu.
The AUTO IMAGE function cannot be operated when the input signal is digital from DVI terminal or "RGB",
"480p", "575p", "HDTV720p", "HDTV1035i" or "HDTV1080i" is selected on the SYSTEM SELECT menu.
Press the AUTO IMAGE button on the Side Control or on the Remote Control Unit to automatically adjust Fine
sync., Total dots and Screen position for most computers. It will take about 10 seconds.
NOTE: Some computers may not be fully adjusted with the "Auto Image Function". In that case, use the
"Picture Image" and/or "Picture Position" adjustments (P32, 33) to make fine-adjust then after the "Auto
Image Function" is executed.
NORMAL FUNCTION
,
,
or
)
AUTO IMAGE FUNCTION
COMPUTER MODE
Standard
Select the arrow to the
direction (described as
,
then press the SELECT
button.
,
or
),and
33
Advertisement
Table of Contents
