Advertisement
SYSTEM INSTALLATION
CONNECT TO THE NMEA 2000® NETWORK
Once the Link Up Gateway is mounted complete, it is possible to
interface it to the NMEA 2000® backbone through the dedicated
plug.
Please ensure to tighten the M12 connector by screwing it onto its
counterpart, so to preserve the water tightness.
A drop cable is not needed unless the total length of the Link Up
device is not enough to reach the NMEA 2000® backbone. In this
case it is possible to extend the total length by using one of the
accessory drop cables.
Please note that NMEA 2000® does not allow drop cables longer
than 6 meters.
Refer to the NMEA 2000® standard for a proper network design.
If power from the NMEA 2000® network is received, the green LED
on the Link Up housing will start flashing (see "LED notifications").
B001030
Advertisement
