Dometic COOLAIR SPX1200T Manual page 11

SPX1200T, SPX1200C, SPX1200I
1.6 SPX1200C
The SPX1200C can only be installed in combination with the SPX1200I or
SPX1200T(evaporator units). The requirements for installing the SPX1200I or
SPX1200T have to be observed as well.
• Dimensions: fig. 3, page 4
• Installation area without inclination to the front or back: fig. 4, page 4
Observe the following notes:
• The use of a vehicle-specific fastening frame is recommended for optimal
installation of the SPX1200C compressor unit to the cabin rear wall.
• Ensure you have enough room for installation on the cabin rear wall.
• Check if the retrofit might damage vehicle components, alter their shape or
impair their functionality.
• Avoid unnecessary and frequent mechanical impact on the supply lines
between the evaporator unit and compressor unit. Damage may lead to
refrigerant leakage and impaired system performance.
• Ensure the compressor unit is not mounted too low on the cabin rear wall.
Otherwise the heat emission from the engine may cause damage to the
system.
EN
Requirements for installation
11