Electrolux EW6F348SA User Manual page 33

2. Touch the Delay Start
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
again to start the new countdown.
10.6 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pause
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Manager is available,
during this phase the Time Manager
bars placed below the time
digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display: in this case, for 30
seconds, it is possible to pause the
appliance and remove the exceeding
garments.
Once removed the exceeding garments,
touch the Start/Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
button
button
10.7 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given
3. Touch the Start/Pause
The washing programme continues.
is
10.8 Cancelling a running
programme
1. Press the button On/Off to cancel the
2. Press the button On/Off again to
button to start
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
information in the display changes
accordingly.
again.
To start the programme
again make sure that the
programme dial is correctly
positioned on the interrupted
programme and the indicator
of the Start/Pause
is flashing.
programme and to deactivate the
appliance.
activate the appliance.
ENGLISH 33
button.
button
button