Table of Contents
Advertisement
32
www.electrolux.com
Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press the On/Off
seconds to activate the appliance.
A short tune sounds.
10.3 Setting a programme
If you wish to change the
automatic detergent or fabric
softener dosage, enter the
AutoDose configuration
mode before proceeding
with any programme setting.
The configuration mode may
cancel temporary settings.
Please refer to "AutoDose
configuration mode"
paragraph in "The AutoDose
Technology (Autodosing)"
chapter.
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Start/Pause
button flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
10.4 Starting a programme
Make sure that the detergent
dispenser is firmly closed,
otherwise programme won't
start.
Touch the Start/Pause
the programme. It is not possible to start
button for a few
.
button to start
the programme when the indicator of the
button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.5 Starting a programme with
the delay start
1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Start/Pause
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows
and the indicator
3. Touch the Start/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
button
.
button. The
.
button to
button
goes off.
button
button to
Advertisement
Table of Contents
