Husqvarna 525RX Operator's Manual page 13

a) Make sure that you operate the socket wrench in
the identified area when you loosen or tighten the
saw blade nut.
To assemble and disassemble the cutting
attachment guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Attach the cutting attachment guard with the bolt (B).
4. Install the drive disc (C) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (D) in the hole to lock the shaft.
B
1345 - 002 - 03.06.2022
Accessories on page 27 .
C
D
E
A
7. Turn the cutting equipment (E) in the opposite
direction from which the cutting equipment rotate.
E
8. To disassemble, follow the instructions in the
opposite sequence.
To adjust the harness
WARNING:
be correctly attached to the harness. Do not
use a defective harness.
1. Put on the harness.
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
4. Adjust the side straps to make the product weigh
equally on your shoulders.
5. Adjust the harness until the cutting attachment is
parallel to the ground.
6. Let the cutting attachment lightly touch the ground.
Adjust the harness clamp to balance the product
correctly.
Note:
If you use a grass blade, it must balance
approximately 10 cm /4 in above the ground.
E
The product must always
13