Download
Share
Print this page
Husqvarna 525HE3 Operator's Manual
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Trimmer
  5. 525HE3
  6. Operator's manual

Husqvarna 525HE3 Operator's Manual

Hide thumbs Also See for 525HE3:

Advertisement

Quick Links

525HE3, 525HE4
EN
Operator's manual
2-18

Advertisement

loading

Related Manuals for Husqvarna 525HE3

Summary of Contents for Husqvarna 525HE3

  • Page 1 525HE3, 525HE4 Operator's manual 2-18...

  • Page 2: Table Of Contents

    Contents Introduction..............2 Maintenance..............12 Safety................4 Transportation, storage and disposal......16 Assembly................ 8 Technical data.............. 16 Operation................ 9 EC Declaration of Conformity........18 Introduction Product description Intended use The product is a hedge trimmer with a combustion Use the product to cut branches and twigs. Do not use engine.
  • Page 3 Symbols on the product Air purge bulb. Stop. Idle adjustment screw. This product can be dangerous and cause serious injury or death to the operator or others. Be careful and use the product correctly. High speed needle. Read the operator's manual carefully and make sure that you understand the instructions before you use this product.

  • Page 4: Safety

    • the product has an accessory that is not from the • the product is not repaired at an approved service manufacturer or not approved by the manufacturer. center or by an approved authority. Safety Safety definitions • Never allow anyone else to use the product without first ensuring that they have understood the contents Warnings, cautions and notes are used to point out of the operator’s manual.
  • Page 5 Do not use a product with defective safety devices. Approved protective goggles must comply with the • Do a check of the safety devices regularly. If the safety devices are defective, speak to your Husqvarna service agent. 1173 - 001 -...
  • Page 6 To do a check of the throttle trigger lockout 2. Move the stop switch to the stop position and make sure that the engine stops. 1. Make sure that the throttle trigger lockout (A) and throttle trigger (B) move freely and that the return spring operates correctly.
  • Page 7 • Make sure that the muffler is correctly attached to • If you spill fuel on your clothing, change clothing the product. immediately. • Do not get fuel on your body, it can cause injury. If you get fuel on your body, use a soap and water to remove the fuel.

  • Page 8: Assembly

    Do not run the product indoors or agent do all other servicing. near flammable material. • Let an approved Husqvarna service agent do • Accessories and changes to the product that are not servicing on the product regularly.

  • Page 9: Operation

    CAUTION: Do not mix fuel for more than 1 • For best results and performance use Husqvarna month at a time. two-stroke oil. • If Husqvarna two-stroke oil is not available, use a two-stroke oil of good quality for air-cooled engines. 1173 - 001 -...
  • Page 10 To fill the fuel tank 2. Push the air purge bulb until the bulb starts to fill with fuel. WARNING: Obey the procedure that follows for your safety. 1. Stop the engine and let the engine become cool. 2. Clean the area around the fuel tank cap. Note: It is not necessary to fill the air purge bulb fully.
  • Page 11 To operate the product • Start near the ground and move the product up along the hedge when you cut the sides. To prepare a warm engine for start 1. Push the air purge bulb again and again until fuel starts to fill the bulb.

  • Page 12: Maintenance

    3. Tilt the cutting unit to the correct position. Use 1 of 4. Tilt the cutting unit to the applicable position. the procedures that follow. a) Use the handle. b) Push the end of the cutting unit against a stable surface.
  • Page 13 Maintenance schedule Maintenance Daily Weekly Monthly Clean the external surface. After each operation. Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri- After each operation. cant. Make sure that the cutting unit does not move at idle speed. Do a check of the stop switch.
  • Page 14 1. Stop the product and let it cool down. 2. Remove the cover to the muffler. 3. Remove the screw holding the spark arrestor mesh. To do a check of the spark plug CAUTION: Use the recommended spark Technical data on page 16 . plug.
  • Page 15 Note: New products are first filled with grease after approximately 20 hours of operation. • Use Husqvarna special grease. Speak to your servicing dealer for more information. 1173 - 001 -...

  • Page 16: Transportation, Storage And Disposal

    Always use approved containers for storage and transportation of fuel. • Empty the fuel before transportation or before long- term storage. Discard the fuel at an applicable disposal location. Technical data Technical data 525HE3 525HE4 Engine Cylinder displacement, cm 25.4 25.4 Idle speed, rpm 2800-3200...
  • Page 17 525HE3 525HE4 Weight Weight, kg Noise emissions Sound power level, measured dB (A) Sound power level, guaranteed L dB (A) Sound levels Equivalent sound pressure level at the operator’s ear, measured according to EN ISO 10517, dB(A) Vibration levels Equivalent vibration levels (a...

  • Page 18: Ec Declaration Of Conformity

    EC Declaration of Conformity Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares that the hedge trimmers Husqvarna 525HE3, 525HE4 with serial numbers dating from 2020 onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVE:...
  • Page 19 1173 - 001 -...
  • Page 20 Original instructions 1159664-26 2020-01-17...

This manual is also suitable for:

525he4