Maintenance; Ordering Replacement Parts - Raider RD-ET02 User Manual

or cable and ensure that the power cable always trails in the hoed soil which will prevent the hoe
blades from traveling over the cable.
6. REPLACING THE POWER CABLE
If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to avoid danger.
7. CLEANING, MAINTENANCE AND ORDERING OF SPARE PARTS
Maintenance and cleaning work on the machine as well as removal of the safety devices may
only be performed when the motor is switched off and the power cable has been pulled.
7.1 CLEANING
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can
seep into the device.
7.2 REPLACE THE HOE BLADES
For safety reasons, we recommend having the hoe blades replaced by an authorized professional
(see address on warranty certificate).
Important!
Wear working gloves. Use only genuine spare parts since otherwise the function and safety of
the machine cannot be guaranteed.

7.3 MAINTENANCE

Ensure that all mounting components (i.e. screws, bolts, nuts etc.) are always tightened so that
the machine can be safely operated at all times.
Store the device in a dry room. All the metal parts should be cleaned and then oil to ensure that
they provide a long life. For best results, clean the plastic parts of the machine with a brush or rag.
Do not use any solvents to remove dirt.
At the end of the season, perform a general inspection of the machine and remove any deposits
which may have accumulated. At the start of each season, ensure that you check the condition
of the machine. If repairs are necessary, please contact one of our customer service centers (see
address on warranty certificate).

7.4 ORDERING REPLACEMENT PARTS

Please quote the following data when ordering replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
13