UFESA PV3600 almeria Instruction Manual page 20

IRONING WITH STEAM
The steam regulator (3) is used to adjust the amount of steam produced when ironing.
Temperatura control (7) Recommended position of the steam regulator (3)
Tip: For better ironing results, iron the last strokes without steam to dry the garment.
DRIP PROTECTION
Your iron is equipped with an anti-drip system. If the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
IRONING WITHOUT STEAM
The steam iron can be used on the dry setting or without water in the water tank. It is best to avoid
having water tank full while dry ironing.
1. Set the steam regulator (3) to the "0" position.
2. Select an appropriate temperature for the type of material being ironed.
SHOT OF STEAM
This can be used to remove stubborn wrinkles or to press in a sharp crease or pleat.
1. Set the temperature control (7) to "max".
2. Press the shot of steam button (2*) repeatedly with intervals of at least 5 seconds.
SPRAY
This can be used to remove stubborn wrinkles.
As long as there is enough water in the water tank, you may use the spray button at any temperature
setting during steam or dry ironing.
Press the spray button (1*) several times while you are ironing.
Do not use the spray function with silk!
VERTICAL IRONING
This can be used to remove creases from hanging clothes, curtains etc.
1. Hang article of clothing on a clothes hanger.
2. Set the temperature control (7) to "max".
3. Operate the iron in a vertical position at a distance of 10 cm / 4 in, and press the shot of steam button
(2*) repeatedly with pauses of at least 5 seconds.
20