Assembly Steps; When Using Water - HOMCOM A61-024 Assembly & Instruction Manual

Assembly Steps

1 .Open the carton, find out all the parts listed on page 3, two adults are required for assembly.
2.Fix ring(2)and board bracket( 4)on board( I )by bolts(5)(24)and nuts(6). After that,use bolts(7)
to fix the top of board bracket( 4 )on the back of board( I )tightly.Insert top pole(l l)into board
bracket(4),fix them by bolts(8)and nuts(9).
3 .Insert top pole( 11 )on the top of middle pole(12),then join the middle pole(12) and bottom
pole( 13) as show, fix these poles together by 4.pc.bolts( 8).
4.Place the base(14)on a chosen playing ground,the surface beneath the base should be
horizontal. Insert the wheel shaft(15)into wheel (16)，base(14 )and end of bottom pole ( 13)
orderly.
5 .Fix one end of the 2pcs pole braces(19) on bottom pole( 13 )by bolt(17)and nut( 18).
Then fix another end of the 2pcs pole braces(19)on base( 14 )by bolt(20)and nut(21).
6.Tighten
Sand
24.Plastic Lid
Filling water

WHEN USING WATER:

-Place the base on a smooth surface only! Without gravel or other sharp objects which could
puncture the base and cause leakage.
- Check the base frequently for cracks and punctures.
- Always check the water level before the game.If a leak is found or the water level is low,lay the
system onto the ground so that it can' t tip over.
-Add a tablespoon of chlorine bleach to the water each time the base is filled with water.This
prevents algae from forming inside the base.