Front Wheel; Rear Wheel - Yamaha TT-R230 2020 Owner's Manual

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
3. Remove the axle nut and washer.
1. Axle nut
Periodic maintenance and adjustment
4. Pull the wheel axle out, and then
EAU24361
remove the wheel. NOTICE: Do
not apply the brake after the
EAU56231
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
EWA10822
To install the front wheel
1. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc into the caliper.
2. Insert the wheel axle, and then in-
stall the washer and axle nut.
3. Lower the front wheel so that it is
on the ground.
4. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
80 N·m (8.0 kgf·m, 59 lb·ft)
5. Push down hard on the handlebar
several times to check for proper
fork operation.

Rear wheel

To remove the rear wheel
[ECA11073]
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Adjusting nut
2. Brake rod
3. Brake camshaft lever
4. Axle nut
7-30
WARNING
EAU25081
EAU56601
EWA10822
7