Spoke Wheels; Adjusting The Clutch Lever Free Play - Yamaha TT-R230 2020 Owner's Manual

Periodic maintenance and adjustment

Spoke wheels

To maximize the performance, durabil-
ity, and safe operation of the vehicle,
note the following points.
 Check each wheel for cracks, de-
formation and other damage. If
any damage is found, have the
wheel inspected by your Yamaha
dealer. Do not attempt to repair or
straighten a bent or damaged
wheel.
 Check the spokes for looseness. If
any loose spokes are found, have
7
the wheel adjusted by your
Yamaha dealer. Improperly tight-
ened spokes can cause wheel
misalignment.
 Have the wheel balanced whenev-
er the tire or tube has been re-
placed. An unbalanced wheel can
result in adverse handling charac-
teristics and shortened tire life.
WARNING
The wheels on this model are not
designed for use with tubeless tires.
Do not attempt to use tubeless tires
on this model.
EAU21945
Adjusting the clutch lever free
play
Measure the clutch lever free play as
shown.
1. Locknut (clutch lever)
2. Adjusting bolt
3. Locknut (clutch cable)
4. Adjusting nut
5. Clutch lever free play
Clutch lever free play:
10.0–15.0 mm (0.39–0.59 in)
Periodically check the clutch lever free
EWA10611
play and, if necessary, adjust it as fol-
lows.
1. Slide the rubber cover back at the
clutch lever.
2. Loosen the locknut.
3. To increase the clutch lever free
EAU22038
TIP
If the specified clutch lever free play
could be obtained as described above,
skip steps 4–8.
4. Fully turn the adjusting bolt in di-
5. Slide the rubber cover back at the
6. Loosen the locknut further down
7. To increase the clutch lever free
8. Tighten the locknut at the clutch
7-17
play, turn the clutch lever free play
adjusting bolt in direction (a). To
decrease the clutch lever free
play, turn the adjusting bolt in di-
rection (b).
rection (a) to loosen the clutch ca-
ble.
clutch cable.
the clutch cable.
play, turn the clutch lever free play
adjusting nut in direction (a). To
decrease the clutch lever free
play, turn the adjusting nut in di-
rection (b).
cable, and then slide the rubber
cover to its original position.